Set up your phone
The antenna
Your device has an internal antenna located towards the top of the phone. Hold the
phone as you would any other telephone with the antenna area pointed up and
over your shoulder.
Note: As with any other radio transmitting device,
do not touch the antenna unnecessarily when the
device is switched on. Contact with the antenna
affects call quality and may cause the phone to
operate at a higher power level than otherwise
needed. Avoiding contact with the antenna area
when operating the phone optimizes the antenna
performance and the battery life.
The battery
Always switch the device off and disconnect the charger before removing the battery.
REMOVE THE BACK COVER
1
Hold the phone upside down,
with the back of the phone
facing you.
2
Push down on the back cover
release button and pull the
bottom of the back cover away
from the phone to remove it.
REMOVE THE BATTERY
3
After you have removed the back cover, insert
your finger into the finger grip and lift the
battery from its compartment.
REPLACE THE BATTERY
1
Position the battery so the gold-colored
contacts match up with those on the phone.
The battery label should be facing away
from
the phone.
2
Insert the battery, gold-colored contact end
first, into the battery slot.
3
Push down on the other end of the battery to snap the battery into place.
10
Copyright © Nokia 2003
REPLACE THE BACK COVER
1
Place the top of the back cover to the locking
catch in the top of the phone.
2
Position the back cover over the locking
catches on the both sides of the phone and
press down at the top and bottom to lock the
cover into place.
CHARGE THE BATTERY
1
Plug the charger transformer in to a standard
ac outlet.
2
Insert the charger output plug into
the round jack at the bottom end of
the phone.
After a few seconds, the battery indicator
in the display starts to scroll from bottom
to top. If the battery is completely flat, it
may take a few minutes before the
charging indicator appears on the
display or any calls can be made.
Turn your phone on or off
1
To turn your phone on or off, press and hold the power
key on top of the phone for at least 3 seconds.
2
Enter the security code if necessary and press OK. See
“Security code” on page 51 for more information.
Connect the headset
A compatible headset may be purchased with your phone or separately as an
enhancement. (See “Enhancements” on page 72 for information.)
1
Plug the headset connector into the Pop-Port™
connector at the bottom end of your phone.
2
Position the headset on your ear.
With the headset connected, you can make, answer,
and end calls as usual.
•
Use the keypad to enter numbers.
•
Press the Talk key to place a call.
•
Press the End key to end a call.
Nokia
6585 User Guide 11
Copyright © Nokia 2003
Set up your phone
Change the Xpress-on
™
covers
Note: Before removing the cover, always switch off the power and
disconnect the charger and any other device. Avoid touching electronic
components while changing the covers. Always store and use the device
with the covers attached.
REMOVE THE BACK COVER AND THE BATTERY
See “Remove the back cover” and “Remove the battery” on page 9 for instructions
on removing the back cover and battery.
REMOVE THE FRONT COVER
1
Press the front cover latch on the top of the
phone while gently pulling the top of the
front cover away from the rest of the phone.
INSTALL THE KEYMAT AND FRONT COVER
2
Remove the key mat from the old front cover
and place it into the new front cover as shown.
3
Insert the side latches towards the bottom
of the new front cover into the matching holes
towards the bottom of the phone.
4
Gently push the latches from the middle of the front
cover into the matching holes in the middle of
the phone.
5
Gently push the cover latch on the top of the front
cover through the locking hole in the top of the
phone, and snap the front cover into place.
REPLACE THE BATTERY AND BACK COVER
See “Replace the battery” on page 9 and “Replace the back cover” on page 10 for
instructions on replacing the battery and back cover.
12
Copyright © Nokia 2003
• MAKE A CALL
Using the keypad
1
Enter the phone number (including the area code), and press the Talk key.
(To delete a character to the left of the cursor, press Clear.)
2
Press the End key to end the call or to cancel the call attempt.
Using the contacts list
1
At the start screen, scroll to the entry you wish to view.
2